Sonitek Hand-Held 40 kHz 400 watt welding system
Model Ultra-Tek 40.4 with HH-4TP
POWER SUPPLY: Digital Frequency Generator and Controller with Intelligent

Cooling System Features:

• Welds by Time, Energy or Peak Power with settable +/- window limits!
  • Auto-tuning with Line and Load Regulation maintains even amplitude
  • Adjustable amplitude from 50% to 100% with digital control.
  • Auto-frequency and Power (wattage) displayed after each cycle
  • Settable amplitude/power ramp up rate for starting larger horns
  • LCD Multi-function display with switch-able on/off back lit display
  • Test Button for vibrating horn or transducer
  • Protection against NO Load operation
  • Overload Protection to protect equipment
  • Power and Status Display and Short Circuit Protection
  • Standard interface for Monitoring and Control with 15 pole D-sub connector.
  • Has thermal protection that turns on internal fan over heat-sink and also will shut
  system down when it gets too hot internally
  • Adjustable LCD display for backlight and contrast

SPECIFICATIONS
Power Supply
: Ambient temperature range -10c -+ 40c
40 kHz @ 400 watts 110Volt; 50/60Hz (also available in 220V)
9.85” wide (250mm) X 2.95” high (75mm) X 7.08” deep (180mm)
P.S. Weight: 6.17 lbs (2.8kg)

HH-4TP Handheld Titanium Probe: (Horn or cable not shown)

Shown with an operator holding the HH-4TP with a horn installed.

Home l I Ultrasonics I Heat Staking I Leasing Info